Ticker

6/recent/ticker-posts

Repair Corrupted Memory card or Pendrive with CMD 2020

 




This method is based on a simple command prompt trick that will forcely format your external drive and then after that you can use it.

Don't Miss: Crack Passwords with Chain & Abel 2020 Easiest way to Crack Passwords

But firstly note that this will delete your all files from USB pendrive and if you have any of important data in then use recovery tool to restore these data before implementing this method. So just follow the simple steps that I have discussed below.

First insert Memory Card/USB Hard Drive with your computer through your USB port and remove all other drives if you have connected.

Now open my computer and note down the drive letter of your USB or memory card.

Now click on start and then type cmd and then press enter.

Don't Miss: How to Find the Exact Location of any IP Address

Now type "disk part" in command prompt and pop up might appears asking for permission, click Allow.

Now type "list disk" there and you will see all the disk will get listed there. As shown in Image below.



Now there you will see your external drive, note down its disk number.(eg. o zero)

Now type "select disk disk_number" (eg select disk 4) and press enter.

Now type "clean" and press enter.

Now type "create partition primary" and then press enter.

Now type "active" and press enter.

Now enter the command "select partition 1".

Now type  "Format fs=fat32" or "Format fs=ntfs" and press enter.

Don't Miss: Turn off Any Android Device by Sending SMS or Call

That's it, it will take some time and after that your drive will get successfully format and become ready to use.

Post a comment

0 Comments